Fig 1 · Drawn to scale
Two particle sizes, two places to land.
A sectioned block of tooth surface sits in a small vise. Above it, a gantry carries two hoppers: a fine trough for nano hydroxyapatite and a wide hopper for micro grains. Watch where each size ends up, or tap the drawing to step through.
- Nano hydroxyapatite, 20–100 nm
- Micro hydroxyapatite, 5–10 µm
- Openings in the surface, 1–3 µm
A sectioned block of tooth surface. Block, openings and particles are drawn to one scale: the openings are 1–3 µm across, about the width of exposed dentinal tubules. Nano particles are 10 to 150 times narrower than an opening, small enough to settle inside it. Micro particles are wider than any opening, so they rest on top of the surface. Lab studies look at nano particles in microscopic defects and tubules, and at micro particles in the mineral layer on the surface.
01 · Nano pass
Small enough to go in
A fine trough sweeps across the block and sifts nano particles, 20–100 nm. Each one is 10 to 150 times narrower than an opening, so they settle inside, and the channels on the cut face fill from the bottom.
02 · Micro pass
Too wide to fit
A wide hopper drops micro grains, 5–10 µm, one at a time. Even the smallest is wider than the largest opening, so each one lands and stays on top of the surface.
03 · Both sizes
Inside and on top
Nano in the openings, micro across the surface. Sizes describe the particles in the tube. They are not a measurement of what happens on your teeth.